notoriouszd

INSTALLING THE CATCH CAN
This is one of the easiest mods to do.. In this section ill show you how easy !
During normal operation, the crankcase presurises and vents via the crankcase breather pipe. In the GU Patrol this pipe is connected back to the air intake, just after the air filter. Oil mist can contaminate the MAF sensor and intercooler as described above.
When doing this mod, it is a good idea to also remove your intercooler and clean it. While it is out, check it for oil stains and leaks. To clean the intercooler, firstly remove the 4 bolts which hold it to the engine, loosen the pipe clamps, undo the boost sensor probe plug on the front and take the intercooler out,
I cleaned mine using degreaser, and then flushed with water. i used a hairdryer to make sure it was clear before replacing it.
The crank case breather pipe is on the top of the engine, just to the right of the intercooler. Click on the photos for a bigger version...

It is normally piped straight to the air inlet here..

Basically what we do is put the catch can inline.. Take the pipe out and use the pipe which comes with the catch can to put the catch can inline..
Most people mount the catch can up against the firewall on the passenger side. Your milage may vary depending on if you have ABS.
Here are a few photos, please ask any questions as a comment below.






---