March 4, 201313 yr comment_7078 I bought a diff centre today but unsure of the ratio! Is there a way to tell the ratio or will it have to go to a diff place to get checked? Report
March 4, 201313 yr comment_7079 Thats pretty simply; count number of teeth on pinion and crown wheel than ratio=driven/driver or ratio=number of teeth on crown wheel divided by number of teeth on the pinion. Cheers Edited March 4, 201313 yr by Rumcajs Report
March 5, 201313 yr Author comment_7082 Ok, so It's a brand new 3:9 ratio and I need a 4:1 Great Report
March 10, 201313 yr Author comment_7090 Is there Spose to be a crush spacer on the drive pinion? Report
March 12, 201313 yr comment_7092 There is/are spacer/s and shim/s to get the pinion bearings pre-load right. There are several sizes available. Cheers Edited March 12, 201313 yr by Rumcajs Report
March 22, 201313 yr comment_7134 What is the tallest ( lowest Reving) ratio on a Gq and how do you know what is in a vehicle without pulling the centres out? Is there a code on the compliance plates? Report
March 22, 201313 yr comment_7137 Looking at the specs it seems the lowest ratio is 3.9, standard was 4.1. There should be a code on the VIN plate like axle type H233B 41 (41 means 4.1 ratio) thats how it is on GU I'm not that sure about GQ. Cheers Report
March 23, 201313 yr comment_7139 You sure know a lot about these things! The Patrol Oracle! LOL, I don't think so, it will be a while before I'm Patrol guru...... Report
Create an account or sign in to comment